TOYO would like to contribute to the development of the industry by supporting the practical examinations for the“Plastic Injection Molding Skill Certification .”
Each year, from mid-July to mid-August, the practical examination for the Plastic Injection Molding Skill Certificationis held at the PLASTAR CS Center in TOYO Head Office. Since 1981, TOYO has been providing the center as the venue for the Plastic Injection Molding Skill Certification practical examination entrusted by the Hyogo Plastic Industrial Association, and we have been providing personnel support for the examination.. too.TOYO has always prepared the then-latest plastic injection molding machines and peripheral equipment and up-dated fixtures and the working environment so that examinees can concentrate on the testing.
The practical examination is quite difficult as only less than 50% can pass the Class 1 and Class 2 examinations on average. In addition, after the passing of the practical examination, the trainees need to sit for a written test at the end of August, and the results, passed or failure, of both examinations are sent to each examinee around early October. Although the passing the exam is not everything, the Class 1 or Class 2 Technical qualification is a reliable method to certify the skill the examinee has built up, and it can also be the target of the daily technical study. In the day of the dissipation of craftsman’s skills from Japan’s shop-floor TOYO is determined to the plastic industry by supporting the molding skill certifying test
Explanatory meeting prior to the practical examination
Practical examination "Setting the molding conditions"
Practical examination"Selecting good parts in earnest"
The practical examination is a race against time.
Practical examination
The completion report must also be submitted within the examination time.
The term “plastic molding technician” is a title under a national skill certification system. It refers to a person who has passed the written and practical examinations related to a plastic molding technician held by the designated organization (Japan Vocational Ability Development Association) according to Clause 1 of Article 47 of the Vocational Ability Development Promotion Law. According to the law, it is forbidden to call him or herself “plastic molding technician” without possessing the certification.
