A diversity of screws (optional)
* SAG design
Gas suppressing screw
|
APPLICATION
|
Suppressing Outgassing |
|---|---|
|
EFFECT
|
Gas-caused defects are reduced. |
* SAT design
High-mixing sub-flight screw
|
APPLICATION
|
High-cycle molding High-mixing plasticization |
|---|---|
|
EFFECT
|
Uniform mixing |
* MIT design
High-mixing screw
|
APPLICATION
|
Resin with Master Batch High-dispersion plasticization |
|---|---|
|
EFFECT
|
Prevent color variability |
* LOT design
Screw for high-viscosity resin
|
APPLICATION
|
PMMA, PC resin for the optical products.Prevent products tarnish. Inhibit shearing heat |
|---|---|
|
EFFECT
|
Good for high-viscosity resin |
* HIT design
Screw for low-viscosity resin
|
APPLICATION
|
PA, LCP resin and Others Low-viscosity resin |
|---|---|
|
EFFECT
|
We have a lot of good record in Connecter molding |
* MIT design
Special high-mixing screw
|
APPLICATION
|
Resin with low Master Batch |
|---|---|
|
EFFECT
|
Good for high-dispersion plasticization |
* SOT design
Special spec screw
|
APPLICATION
|
Shallow groove screw Turbulent type high-mixing screw |
|---|---|
|
EFFECT
|
Special design screw according to customers request. |
* Other
|
APPLICATION
|
Increasing corrosion resistance (C-TiN coating) Prevent adhesion and accumulation of resin （CrN coating） We have other coating screws also. |
|---|
A diversity of nozzles (standard and optional)
* Small diameter I
(Heater O/D : 26mm)
|
APPLICATION
|
Standard specs : up to 20mm |
|---|
* One-piece type
|
APPLICATION
|
Standard specs : 24mm to 36mm |
|---|
* Separate type
|
APPLICATION
|
Standard specs : from 40mm Optional : up to 36mm |
|---|
* High-performance chip type
|
APPLICATION
|
Optional : 16mm to 32mm |
|---|
* One-piece long type
|
APPLICATION
|
For various special-shaped products |
|---|
* Special type
|
APPLICATION
|
For hot runner mold products |
|---|
A diversity of screw check triplet (standard and optional)
* Screw check triplet (non-rotating)
|
EFFECT
|
Reduce the wearing of the ring circumference and inner periphery of the heat barrel because the check-ring doesn't rotate. |
|---|
* Screw check triplet for SRC-III metering control
|
EFFECT
|
SRC-III is good for stabilize the product weight especially the molding without holding pressure process. SRC-III can also stabilize repeat-stability because packing pressure will be stable. |
|---|
* CrN, C-TiN-coated screw check triplet
|
EFFECT
|
Increasing corrosion resistance (C-TiN coating) Prevent adhesion and accumulation of resin （CrN coating） |
|---|
